The commonly used ultra-thin light boxes are generally the four-sided opening type (except for the suction cup type and crystal ultra-thin light boxes). The following are the most frequently used steps for changing the picture, which are summarized as follows:
Place the ultra-thin light box flat on the countertop.
2. The profiles around are pushed open.
3. Remove the surface panel;
4. Tear off the transparent plastic film covering the panel.
5. Wipe the side of the panel where the plastic film has been removed clean.
6. Stick 3mm-wide double-sided tape around the panel, which is exactly the size of the picture.
7. Take out the picture that has been wiped clean in advance and cover the side of the picture that is facing the panel with double-sided tape.
8. Use your hands or a cloth to smooth out the picture.
9. Remove the double-sided tape. At this step, while removing the double-sided tape, use a cloth to smooth out the air between the picture and the panel.
10. Smooth out the pasted picture.
11. Remove the protective paper on the other side of the panel and wipe it clean.
12. Put the panel with the picture pasted back into the ultra-thin light box, ensuring it is balanced up, down, left and right.
13. Cover the four sides of the profile side covers.
14. At this point, the installation of the screen is complete. You can also directly place the picture on the light guide plate, remove the protective paper and plastic film of the panel, and then place it on the picture and cover it with the profile frame
The commonly used ultra-thin light boxes are generally the four-sided opening type (except for the suction cup type and crystal ultra-thin light boxes). The following are the most frequently used steps for changing the picture, which are summarized as follows:
Place the ultra-thin light box flat on the countertop.
2. The profiles around are pushed open.
3. Remove the surface panel;
4. Tear off the transparent plastic film covering the panel.
5. Wipe the side of the panel where the plastic film has been removed clean.
6. Stick 3mm-wide double-sided tape around the panel, which is exactly the size of the picture.
7. Take out the picture that has been wiped clean in advance and cover the side of the picture that is facing the panel with double-sided tape.
8. Use your hands or a cloth to smooth out the picture.
9. Remove the double-sided tape. At this step, while removing the double-sided tape, use a cloth to smooth out the air between the picture and the panel.
10. Smooth out the pasted picture.
11. Remove the protective paper on the other side of the panel and wipe it clean.
12. Put the panel with the picture pasted back into the ultra-thin light box, ensuring it is balanced up, down, left and right.
13. Cover the four sides of the profile side covers.
14. At this point, the installation of the screen is complete. You can also directly place the picture on the light guide plate, remove the protective paper and plastic film of the panel, and then place it on the picture and cover it with the profile frame
