Soft film light box picture always suck into how to do?

The problem of absorbing the soft film light box picture can be solved by adjusting the air pressure in the light box and checking the soft film binding situation.

If the air pressure inside the light box is unbalanced, it may cause the soft membrane to be sucked. At this time, you can try to open or close the ventilation hole of the light box to adjust the air pressure in the light box, so that it reaches a balance state. In the adjustment process, it is necessary to gently pull the soft film and observe whether the problem of soft film absorption can be solved smoothly.

In addition, if the soft film is not properly tied, it may also cause the air pressure imbalance in the light box, which will affect the smoothness of the soft film. Therefore, you need to check whether the binding of the light box soft film is reasonable, and if it is loose, it should be re-tied in time to ensure that the soft film can remain flat and not be sucked.

If the above methods still cannot solve the problem, or the soft film is seriously deformed due to suction, affecting the beauty, then you may need to consider replacing the soft film. When replacing the soft film, the soft film with good quality and appropriate specifications should be selected, and the operation should be carried out in accordance with the correct installation method to avoid the recurrence of similar problems.

If the soft film light box picture frequently sucked into how to deal with?

Soft film light box screen is frequently sucked into, can be dealt with from the following aspects.

Check fan power and Settings. If the fan power is too large, it will produce strong suction resulting in the screen being sucked, you can replace the fan with the right power, or adjust the wind speed of the fan to reduce the suction, so that the air flow in the light box is stable.

Check light box tightness. If the light box is not tightly sealed, the outside air enters the air flow, which may suck the picture. Carefully check the edge and joint of the light box, seal with sealant, sealing strip and other materials to prevent abnormal air entry.

Fixed the soft film picture. The picture is not fixed firmly and easy to be sucked. Special borders or glue can be used around the soft film to firmly fix it to ensure that the picture is smooth and tight, enhance stability and reduce the risk of being sucked.

Check the internal structure of the light box. Check whether any part is loose or displaced to form an air flow channel, repair or adjust the internal structure in time, and keep the air flow inside the light box uniform.